Por favor, use este identificador para citar o enlazar este ítem:
http://cicy.repositorioinstitucional.mx/jspui/handle/1003/1818| Effect of type and concentration of nanoclay on the mechanical and physicochemical properties of Bis-GMA/TTEGDMA dental resins | |
| JUAN JOSE ENCALADA ALAYOLA Yaymarilis Veranes Pantoja Jorge Alonso Uribe Calderón JUAN VALERIO CAUICH RODRIGUEZ JOSE MANUEL CERVANTES UC | |
| Acceso Abierto | |
| Atribución-NoComercial-SinDerivadas | |
| doi:10.3390/polym12030601 | |
| DENTAL RESIN COMPOSITE MONTMORILLONITE PALYGORSKITE | |
| Bis-GMA/TTEGDMA-based resin composites were prepared with two different types of nanoclays: an organically modified laminar clay (Cloisite® 30B, montmorillonite, MMT) and a microfibrous clay (palygorskite, PLG). Their physicochemical and mechanical properties were then determined. Both MMT and PLG nanoclays were added into monomer mixture (1:1 ratio) at different loading levels (0, 2, 4, 6, 8 and 10 wt.%), and the resulting composites were characterized by scanning electron microscopy (SEM), thermogravimetric analysis (TGA), dynamic mechanical analysis (DMA) and mechanical testing (bending and compressive properties). Thermal properties, depth of cure and water absorption were not greatly affected by the type of nanoclay, while the mechanical properties of dental resin composites depended on both the variety and concentration of nanoclay. In this regard, composites containing MMT displayed higher mechanical strength (both flexural and compression) than those resins prepared with PLG due to a poor nanoclay dispersion as revealed by SEM. Solubility of the composites was dependent not only on nanoclay-type but also the mineral concentration. Dental composites fulfilled the minimum depth cure and solubility criteria set by the ISO 4049 standard. In contrast, the minimum bending strength (50 MPa) established by the international standard was only satisfied by the dental resins containing MMT. Based on these results, composites containing either MMT or PLG (at low filler contents) are potentially suitable for use in dental restorative resins, although those prepared with MMT displayed better results. | |
| 2020 | |
| Artículo | |
| Polymers, 12(3), 601, 2020. | |
| Inglés | |
| Encalada-Alayola, J. J., Veranes-Pantoja, Y., Uribe-Calderón, J. A., Cauich-Rodríguez, J. V., & Cervantes-Uc, J. M. (2020). Effect of type and concentration of nanoclay on the mechanical and physicochemical properties of Bis-GMA/TTEGDMA dental resins. Polymers, 12(3), 601. | |
| RESISTENCIA DE MATERIALES | |
| Versión publicada | |
| publishedVersion - Versión publicada | |
| Aparece en las colecciones: | Artículos de Investigación Arbitrados |
Cargar archivos:
| Fichero | Tamaño | Formato | |
|---|---|---|---|
| 2020_Encalada_Alayola.pdf | 2.12 MB | Adobe PDF | Visualizar/Abrir |